I modified the design so that it has usable handles even if the wires are routed to the side to […]
I have finally worked out the magic formula to 3D print a female ECU connector using cheap and easily obtainable […]
Over the decades the gold surface on the PCB becomes worn and could lead to problems with idle and acceleration. […]
This is a manual from Mercedes used to educate workshop technicians in the 1970s on the new D-Jetronic electronic fuel […]
All of these drawings I created myself from reverse-engineering the parts in a type 3 MPS. Print at 100% (no […]
The two coils are wound around a plastic spool with four wire connectors mounted onto the spool. The spool is […]
The aneroid cell pushes on the core, pressing it rearwards into the coil. A spring provides an opposing force and […]
I’ve spent the last week or so modeling all 68 parts in an MPS that @cushjbc kindly leant me to take apart. […]
Here are the details of the male connector found on the engine wiring harness.
